shop-talk
[Top] [All Lists]

RE: Water pumps

To: <shop-talk@autox.team.net>
Subject: RE: Water pumps
From: "Randall Young" <ryoung@navcomtech.com>
Date: Mon, 30 Dec 2002 22:08:59 -0800
> How do I go about draining and refilling the system, in particular
> the pressure tank? I'm assuming that the tank is basically empty,
> the air pocket at the top gets pressurized to the pump's cutoff
> and provides pressure to the system until it drops below cutin.
> If I drain the pressure tank, do I bleed it? How far? I see a
> schraeder valve at the side, which I've used to measure
> the pressure and calibrate the system's gauge.... or do I bleed up
> to the valve and then pressurize?

If it has a Schrader valve, then there's a very good chance it has a bladder
inside to separate the air from the water.  This makes the air cushion last
far longer.  I'm not sure of the correct procedure to adjust the amount of
air in the tank; what I've done is to shut off the pump, open a faucet above
tank level, wait until the water stops flowing, then add a burst of air and
see if more water comes out.  Keep adding small shots of air until no more
water comes out.

Randall

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/shop-talk


<Prev in Thread] Current Thread [Next in Thread>