Re: Misc junk: welding to stainless, car jack pads, and tracing

["Arvid Jedlicka" <arvidj@visi.com>]

> I could have sworn that the
> jack I saw had something to lift a car by the pinch weld; looked sort of
like
> a plastic block with a slit in it, but the jack I got has a standard
cup-like
> lift pad.  Do you guys know what I'm talking about and where to get one?

I found my pinch weld device on the table saw on the bottom of a 2x4.

Had to run it through a couple of times (blade height slightly higher than
the pinch, width as desired) but it was there. Really.

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/shop-talk