shop-talk
[Top] [All Lists]

Re[2]: Question about Radiant Heated Floors and drilling for

To: "Phil Ethier" <pethier@isd.net>
Subject: Re[2]: Question about Radiant Heated Floors and drilling for
From: Bill Gilroy <w.gilroy@verizon.net>
Date: Thu, 27 Dec 2001 06:32:02 -0500
Hello Phil,

Wednesday, December 26, 2001, 11:59:58 PM, you wrote:



PE> I have worked on many lathes and milling machines over the years, including
PE> some big CNC rigs.  I don't think any of them have been bolted to the floor.

A two post lift needs to be bolted down to the floor.  Not a thing in my
garage is bolt to the floor.

-- 
Best regards,
 Bill                            mailto:w.gilroy@verizon.net

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/cgi-bin/wilma/shop-talk


<Prev in Thread] Current Thread [Next in Thread>