On Thu, 7 Nov 1996, Peter Schauss x 2014 wrote:
> What is the best kind (and source) of flanging tool to put a flange
> on a patch section for a front fender. I bought a patch section
> for the bottom 10" of the front fender on my MGB and it looks like
> the best way to weld it in would be to make a kind of offset (flange?)
> along the top edge like this
>
> |
> | <- Original fender
> | |
> | |
> \ <- Run a bead with the MIG welder here
> |
> | <- Patch section
> |
>
> Thanks in advance,
>
I have a pneumatic flanger that operates off my air compressor. One jaw
sets a flange, another punches a 3/16 inch hole for plug welding. It
works very well.
Ray Gibbons Dept. of Molecular Physiology & Biophysics
Univ. of Vermont College of Medicine, Burlington, VT
gibbons@northpole.med.uvm.edu (802) 656-8910
|