If there is this much problem with P-type manifolds, why doesn't some one get
batch made. ???????????????
----- Original Message -----
From: Dave & Diana Dwyer
To: mg-mmm@autox.team.net
Sent: Thursday, August 22, 2002 7:36 PM
Subject: Re: P-type Exhaust Manifold
Phil
In addition to the one on the car, we have two spares. All three have been
cracked, usually at the bottom flange due to the muffler hitting something
solid. I suspect this is a very common problem.
I would suggest that your best course would be to seek out a welder of cast
iron and have yours repaired. If it's beyond repair contact me off-list and
maybe I can help.
Regards
Dave Dwyer
J2 (with a P-type engine!), TA, TC
/// unsubscribe/change address requests to majordomo@autox.team.net or
try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|