Jerry,
OK, now you've gotten my curiosity up. I've always understood that a
three-brush dynamo could not be used with a regulator. Or is this just
urban legend?
Perhaps you could share a bit more detail. I'm curious how this is
wired, as I'd sure like to use a better setup than a cutout with the
DDS14.
Regards,
Lew Palmer
-----Original Message-----
From: owner-mg-mmm@autox.team.net [mailto:owner-mg-mmm@autox.team.net]
On Behalf Of Gerald Felper
Sent: Wednesday, January 30, 2002 11:30 AM
To: Lew Palmer
Cc: Kellmg@aol.com; mg-mmm@autox.team.net
Subject: Re: fuse box-cutout PA
Lew & Brain
The two coil regulator can be used with the three brush generators.
Jerry Felper
Lew Palmer wrote:
> Don and Brian.
>
> My Lucas catalog shows the same thing. The RJF2 is a regulator, not a
> cutout. I will have two coils, not one, and is used in conjunction
with
> a standard two-brush dynamo, not the 3-brush unit as normally fitted
to
> the Triple-M cars.
>
> I seem to remember that there is an article somewhere (MMM Yearbook?)
> that describes converting to a two-brush dynamo.
>
> But, as it stands, do not try to use the RJF2 with the standard DDS14
> dynamo.
>
> Regards,
> Lew Palmer
>
> -----Original Message-----
> From: owner-mg-mmm@autox.team.net [mailto:owner-mg-mmm@autox.team.net]
> On Behalf Of Kellmg@aol.com
> Sent: Tuesday, January 29, 2002 4:34 PM
> To: mg-mmm@autox.team.net
> Subject: Re: fuse box-cutout PA
>
> Hi Don,
>
> All I can tell you is the fact that it is listed in the 1935 Lucas
cat.
> So,
> your assumptions should be correct. The 337571 is the ordering number
of
> the
> complete unit. The cat. doesn't cross reference units so, I can't be
of
> any
> extra help.
> >From a 1946 cat. it leads you to believe that,
> CJR incorporates Cutout, Junction box, Fuses
> RJF incorporates Regulator, Junction box, Fuses.
>
> Does your RFJ 2 have more than one relay in it. The RFJ, I imagine
reads
> Regulator, Fuses, Junction box. If this is the case you would have a
> cutout
> and a regulating coil in the upper portion. ??? If this is the case
it
> wouldn't have incorporated the third brush style dynamo.
>
> Brian Kelly.
> In a message dated 01/29/2002 3:07:41 PM Central Standard Time,
> DSBonar@aol.com writes:
>
> > I have been given a Lucas RJF2 Type L 10 for use on PA 1823.
According
> to
> > Moss catalog, PA should have a Lucas CJR 2. Since I don't have the
> original
> > I
> > have no way to compare.
> >
> > On the cover is reads:
> >
> > RJF2 Type L 10
> > 337571
> > 12V ER 10 34
> > (assuming serial #, 12 volt made October of 1934)?
> >
> > On a paper fuse guide under fuses on the "bottom or ... against the
> > firewall"
> > of the unit is printed:
> >
> > CJR 3 - 336194
> >
> > Can one of you fuse experts tell me what I have and will it
substitute
>
> > properly?
> >
> > Thanks
> >
> > Don B
> >
> > ///
>
> /// unsubscribe/change address requests to majordomo@autox.team.net
or
> try
> /// http://www.team.net/cgi-bin/majorcool
> /// http://www.team.net/mailman/listinfo
> /// Archives at http://www.team.net/archive/mg-mmm
> /// Send list postings to mg-mmm@autox.team.net
>
> /// unsubscribe/change address requests to majordomo@autox.team.net
or try
> /// http://www.team.net/cgi-bin/majorcool
> /// http://www.team.net/mailman/listinfo
> /// Archives at http://www.team.net/archive/mg-mmm
> /// Send list postings to mg-mmm@autox.team.net
/// unsubscribe/change address requests to majordomo@autox.team.net or
try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|