Good point Fred, we'll check it out!
|Greg
Fred Schroeder wrote:
> Did you insure that the valve clearances were correct? A tight valve will
> play hell with compression.
>
> Best regards,
>
> Fred Schroeder
> '70 2000
> SRL311-13359
> TDROC
> Home page http://home.texoma.net/~sitsinwest/
>
> ----- Original Message -----
> From: "Allen Blackmon" <orangedawg@hotmail.com>
> To: <datsun-roadsters@autox.team.net>
> Sent: Tuesday, December 10, 2002 5:04 PM
> Subject: Timing: Here we go again
>
> > To List,
> >
> > In my incredibly frustrating attempt to get my car started and running
> > successfully, I've, as you know, run into a number of problems. Latest
> > concern is bent valves.
> >
> > Compression values how shop set up timing:
> > #1: 90
> > #2: 105
> > #3: 150
> > #4: 150
> >
> > I move cam tooth over one and this is waht I got:
> > #1: 95
> > #2: 105
> > #3: 190
> > #4: 180
/// datsun-roadsters@autox.team.net mailing list
/// Archives at http://www.team.net/archive
|