Damian Hall wrote:
> Good-day to all,
> Before my rambling puts people off, I have one main technical question
>(body). > Is there an insulator that should be found between the body mounts
>and the frame connections? What should I use? The PO supplied what look like
>large washers cut from 8mm rubber belting. Currently the body is just sitting
>on the frame.
Damian,
Welcome to the list.
There used to be some felt type material between the body and frame. It would
absorb water and rust the body out. People on the list have recommended that a
high density CLOSED CELL foam or the rubber pads that you have be used.
Neither will hold water and will help protect against rust. The PO of your car
did the right thing by eliminating the felt pads.
Bob
|