<I just recently ordered a new boot and was told the oval type is the only
one
>available. So, if you have a round hole as I did the boot will be big. >
I have both in stock for the 1600 0r 2000
Mike Kerr
Roadster Restoration
3730 Todrob LN.
Placerville CA. 95667
Ph.# 530-644-6777
Fax# 530-644-7252
E-mail: mikekerr@innercite.com
Web page : http://www.innercite.com/~wolfgang
Visa & master card
-----Original Message-----
From: 70 - SPL311 <erwilsey@ix.netcom.com>
To: Matt Peterson <pete_303@hotmail.com>
Cc: datsun-roadsters@autox.team.net <datsun-roadsters@autox.team.net>
Date: Monday, September 27, 1999 8:19 AM
Subject: Re: shifter boot question
>Hi Matt,
>
>I just recently ordered a new boot and was told the oval type is the only
one
>available. So, if you have a round hole as I did the boot will be big. It
does
>go on the metal floor.
>
>Good luck!
>
>Jim
>
>Matt Peterson wrote:
>
>> Hi everyone,
>>
>> I have a quick question. Does the shifter boot attach to the center
console
>> plate or to the metal that is part of the floor? I think my center
console
>> may have been jacked by a previous owner so I can't tell if it should fit
>> there. I tried to fit it to the metal underneath but the hole was too
small
>> for the rubber boot. I think I might end up modifying that part of the
>> center console anyway because it looks like crap right now. Definatly
not
>> original.
>>
>> Thanks,
>>
>> Matt Peterson
>> 68 1600 (will be in the garage soon to wait out the snowy season)
>> Zimmerman, MN
>
>
>
>
|