bricklin
[Top] [All Lists]

Re: Side Molding

To: Stephen.Early@mbna.com, bricklin@autox.team.net
Subject: Re: Side Molding
From: GLCurley@aol.com
Date: Sat, 4 Dec 2004 00:02:44 EST
Where did the Bricklin Boys get the molding?

George


> X-INFO: INVALID TO LINE
> Don,
> 
> Rick summed the replies up well.  I ended up getting the molding through
> Bricklin Boyz.  You can contact them via email at wasteland1@rogers.com
> 
> Stephen I. Early 
> Portfolio Conversions 
> Technology Sector-MBNA America 
> 302.457.4788 
> 800.441.7048 x74788 
> stephen.early@mbna.com 
> 
> 
> 
> -----Original Message-----
> From: High Tech Coatings [mailto:rick@hightechcoatings.com]
> Sent: Friday, December 03, 2004 12:44
> To: bricklin@autox.team.net
> Subject: Re: Side Molding
> 
> 
> I replied on the list but here goes again, I have some NOS of the newer
> grained stuff, not a whole set, but some pieces. I told him to try bob or
> terry, Others told him that body shop supply houses have some that is close,
> it is about 1/8" narrower. Rich Haines in Ohio may have a set or 2 also.
> Rick
> 
> ----- Original Message ----- 
> From: "blownh-d" <blownh-d@jymis.com>
> To: "ZZ9" <bricklin@autox.team.net>
> Sent: Friday, December 03, 2004 12:21 PM
> Subject: Side Molding
> 
> 
> >A couple days ago Stephen Early wrote a message to Bricklin@autox
> >thanking people
> >for all the replies regarding where to find the side molding.
> >
> >I too was interested in locating a resource for the molding and hoped to
> >gain that info
> >via answers to his request. It appears the requested info only went to
> >Stephen and did
> >not go to this forum for the rest of us to use in pursuit of our
> >restorations.
> >
> >Please share this knowledge by sending info to Bricklin@autox, not the
> >individual.
> >
> >Thanks,
> >Don    #1880  #2745




<Prev in Thread] Current Thread [Next in Thread>