Where did you disconnect it and how?
This is 1974 model year.
----Original Message Follows----
From: Jim Pivirotto <jimp@CORP.FirstIndustrial.com>
To: 'Steve Owens' <go2toa@hotmail.com>
Subject: RE: throttle linkage cable ?
Date: Wed, 30 Oct 2002 16:50:29 -0600
I don't know what year your Brick is but it should be an easy disconnect as
I have done it on several occasions Pugs 756
-----Original Message-----
From: Steve Owens [mailto:go2toa@hotmail.com]
Sent: Wednesday, October 30, 2002 3:33 PM
To: Bricklin@autox.team.net
Subject: throttle linkage cable ?
I'm trying to remove the throttle linkage cable and I'd much prefer to
re-use it -- therefore I do not want to simply cut the cable. The problem
is that the attachments at the pedal and at the carb appear to be permanent
assemblies. Has anybody been able to get disconnect their cable intact? If
so, how did they do it?
I think the factory installed it by using a metal junction that is just
forward of the firewall grommet. This junction does not appear to be
something that can be pulled or twisted apart temporarily.
_________________________________________________________________
Broadband? Dial-up? Get reliable MSN Internet Access.
http://resourcecenter.msn.com/access/plans/default.asp
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/bricklin
|