Re: Skid Plate Fabrication

[Viet-Tam Luu <viettamluu@gmail.com>]

On 12/5/05, james creasy <jcreasy@perforce.com> wrote:
> hacksaw and hammer?   cutting wheel on a grinder works great too.

Cutting is straightforward, folding a bit less so. It turns out that
it takes a lot of mechanical effort to bend a several-foot-wide plate
of quarter-inch-thick metal. But maybe you've been working out more
than I have.  ;-)

--
Viet-Tam Luu (a.k.a. "Tam")
SFR-SCCA Solo2 #149 SM
Sponsored by WORKS (www.WorksEvo.com)