Yeah I was mentioning that you cant get the panels open with the bar in place.
Remove the door and its a non issue.
Ugly, but a non issue.
Jarrid
-----Original Message-----
>From: Ramon Spontelli <rspontelli@earthlink.net>
>Sent: Nov 18, 2009 5:58 PM
>To: alpines@autox.team.net
>Subject: Re: [Alpines] AutoPower roll bar clearance
>
><< You have zero chance of getting the soft top out of the top cover panels
>though.>>
>
>It might not be quite that bad Jarrid.
>
>We've never had a soft top on the Series II, so I can't say for sure, but on
>our Mk I Tiger we can get the soft top up and down by completely removing
>the two side pieces of the enclosure. Yeah, it's a pain, but it can be
>done, at least on the Mk I Tiger. Is there some reason it couldn't be done
>on the Series II?
>
>Ramon
>_______________________________________________
>Support Team.Net http://www.team.net/donate.html
>
>Alpines@autox.team.net
>http://autox.team.net/mailman/listinfo/alpines
>
>http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Alpines@autox.team.net
http://autox.team.net/mailman/listinfo/alpines
http://www.team.net/archive
|