goodparts are the best!!!!!
my car is full of them!!!!!
----- Original Message -----
From: "Jim Jones" <jimjcmo@yahoo.com>
To: "6pack" <6pack@autox.team.net>; "Bill Wellbaum" <wcwellbaum@cox.net>
Sent: Monday, October 12, 2009 9:37 PM
Subject: Re: [6pack] Suspension bushings
> Many listers have used uerethane bushings successfully, though I seem to
> remember that there were a few comments about squeaking a bit following
> installation.
>
> I have nylatron bushings that were obtained from Goodparts. I have had
> ZERO
> problems with noise or rear end sagging from worn bushings. For my money,
> buy
> these from Goodparts. He's a great supporter of the hobby and has a well
> deserved reputation for helping out with problems, should they ever arise.
>
> Jim
>
> --- On Mon, 10/12/09, Bill Wellbaum <wcwellbaum@cox.net> wrote:
>
>
> From: Bill Wellbaum <wcwellbaum@cox.net>
> Subject: [6pack] Suspension bushings
> To: "6pack" <6pack@autox.team.net>
> Date: Monday, October 12, 2009, 7:41 PM
>
>
> I almost dread opening this thread but I've forgotten the general
> consensus
> on
> which way to go: I need to replace the swingarm bushings in the TR-6. I
> may
> do the diff at the same time. I did them last in 1994 with standard
> rubber
> items. The car gets driven maybe 1,000 miles a year--no competition, just
> plain old street driving. What is the current thought on the best way to
> go
> --so that I never have to do this again. And from whom should I purchase
> them? I'm certain the heat here in the Las Vegas Valley has contributed
> to
> their failure.
>
> Bill Wellbaum
> Las Vegas
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|