Mike--- One way to avoid unnecessary holes would be to screw some transfer
punches into the captive nuts used to hold the seat rails in place. These
punches can be made by grinding bolts of the appropriate thread to a sharp
point. Lay the carpet in the right place, and strike with a soft hammer or
something where the punch points are. Remove the carpet and further open the
holes to the bolt size with a hole puncher. (Cheap hole punch sets available
from Harbor Freight).
Dick
-----Original Message-----
From: Corbitt, Michael
Sent: Tuesday, April 28, 2009 10:52 AM
To: 6pack@autox.team.net
Subject: [6pack] Carpet Installation
When laying down new carpet, what are the best methods for locating the
seat mounting holes? It pains me to cut brand new wool carpet, and
would pain me even more to end up with swiss cheese.
Mike
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
You are subscribed as tr6taylor@webtv.net
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|