Al,
If you are installing a speedi sleeve on the crank in addition to installing
a new OD transmission my recommendation would be to remove the motor (and
transmission if still installed), install the speedi sleeve on the crank where
it's a lot more accessable, bolt the tranny back to the motor (also a lot
easier) and then reinstall them as one piece. I used a hydraulic engine hoist
with one of those angle adjustors on the chain and did it by myself in about
1/2 hour or so. It seemed a lot simpler than the way you are contemplating.
My trans was an OD also.
Mike Lunsford, 1970 TR 6 TBI.
---------------------------------
Looking for last minute shopping deals? Find them fast with Yahoo! Search.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|