The easiest way is to wedge your long wrench against the frame, and
hit the starter, spins that sucker right off ...
Good Luck
>I used the "rope trick" and an impact wrench to remove this bolt
>when I was putting in an electric fan a couple of months ago. A
>torque wrench with the "rope trick" were used when the shorter
>extension and bolt were put back in.
>
>Rob
>74 TR6 daily driver
>
> 11:30 PM -0700 8/28/05, Sally or Dick Taylor wrote:
>> Jim---This bolt does have the right handed thread. Chances are there is
>>some Loctite involved. Sometimes the engine will "turn over" when
>>losening this bolt, so you may need to jar it loose with an impact
>>wrench, OR hold onto the fan extension with a pipe wrench when doing the
>>loosening.
--
Bill Pugh
1957 TR3 TS16765L
aka
Casper
1970 TR6 CC59179L
aka
Rosey
Wallace, CA
|