i used carb cleaner on the first of 3, didn't like it really
the next 2 i just sprayed off the heavy stuff with starter fluid and carb
cleaner then soaked them in phosphoric acid cleaner i bought at lowes $16 a
gallon. i kept the cleaner and throw anything corroded or rusty in it now,
takes it right off. leaves a grayish film that can be rubbed off. or buffed
off
----- Original Message -----
From: "Brian Finck" <brian.finck@powerhouse.ca>
To: "'Vink, Graham'" <vinkg@fleishman.com>; "6pack" <6pack@autox.team.net>
Sent: Wednesday, October 30, 2002 7:28 AM
Subject: RE: advice on generic parts cleaner?
> Hey Graham,
>
> I use denatured kerosene, the type you get for heaters at the local farm
> supply store, then add a pint of ATF, to keep it from drying out your
hands
> too much (old bike mechanics trick). It works well, and isn't too foul
> smelling, plus it's relatively cheap. A couple of years ago I tried some
> cleaner that was specifically for that purpose (can remember the brand
name)
> and the kerosene worked better, and was easier on the hands.
>
> Brian
>
> -----Original Message-----
> From: Vink, Graham [mailto:vinkg@fleishman.com]
> Sent: Wednesday, October 30, 2002 9:36 AM
> To: 6pack
> Subject: advice on generic parts cleaner?
>
> I have one of those small recirculating parts washers and am wondering
what
> to use in it. Total capacity is probably two gallons.
>
> In the past, I've used mineral spirits, which is not too toxic. I'm sure
> methyl chloride is better, but it's nasty and also more expensive. Does
> anybody have any other suggestions?
>
> Thanks.
>
> Graham
|