I have also had good luck with the cardboard ones.
Jim
----- Original Message -----
From: "Walter Fogle" <lbc4me@hotmail.com>
To: <>
Cc: <6Pack@autox.team.net>
Sent: Tuesday, July 24, 2001 1:31 PM
Subject: Re: Glovebox
> HI Corey:
>
> Amazingly, I just installed a new OEM style cardboard glovebox in my
'69 TR6
> this past weekend. It's virtually identical to the original unit. I
> purchased it from British Parts Northwest (1-503-864-2001); cost was
$21,
> about half the price of the ABS type. It's made in the UK and can be
fitted
> to LHD and RHD cars alike. There are prepunched templates on either
side of
> the unit to fit the light socket. I didn't encounter any particular
> difficulties in installation; just had to temporarily remove one end
of the
> heater hose and under-dash vent hose (with mounting bracket) in order
to
> wangle the unit in place.
>
> P.S. Your windshield washer motor parts are in the mail today. I
included
> the electrical terminals and screws.
>
> Best regards,
> Walt Fogle
> '69 TR6, CC30689L
> Woodinville, WA
>
> Cory wrote:
>
> >
> >After reviewing the LIST's archive I'm not too sure what to do
regarding
> >repair or replacement of my cardboard glovebox. I read a recent
article in
> >Spitfire>6 (#3) magazine on how rebuilt your own, but don't fancy
the
> >task.
> >
> >TRF & Moss offers a plastic replacement, but I they look boxy and I
kinda
> >like to look of the original.
> >
> >Any advice?
> >________________________
> >Corey Sherman
> >CC57269LO
> >corey.sherman@rcn.com
>
>
> _________________________________________________________________
|