9.5 to 1 head thickness? and pushrods

6pack

9.5 to 1 head thickness? and pushrods

from [mitch]

To:	"6pack" <6pack@autox.team.net>
Subject:	9.5 to 1 head thickness? and pushrods
From:	"mitch" <tristatelining@isoc.net>
Date:	Mon, 16 Jul 2001 09:10:36 -0400

Can anyone tell me  what thickness my head should be shaved to . I will have
20 over pistons and want to get to 9.5 to 1. No more than that.
Also i've seen pushrods that say they are shorter or can be shortened for high
compression heads. At what point do you need to use these and not stock
length?
Thanks

[More with this subject...]

<Prev in Thread]	Current Thread	[Next in Thread>
9.5 to 1 head thickness? and pushrods, mitch <= Re: 9.5 to 1 head thickness? and pushrods, Don Fwd: 9.5 to 1 head thickness? and pushrods, StuBeatty Re: 9.5 to 1 head thickness? and pushrods, Sally or Dick Taylor Re: 9.5 to 1 head thickness? and pushrods, Sally or Dick Taylor Re: 9.5 to 1 head thickness? and pushrods, Sally or Dick Taylor

Previous by Date:	Re: How to service rear wheel bearings x-mac-creator="4D4F5353", Sally or Dick Taylor
Next by Date:	Oil Pressure with Spin on Adapter, Chris Kincer
Previous by Thread:	Re: How to service rear wheel bearings x-mac-creator="4D4F5353", Sally or Dick Taylor
Next by Thread:	Re: 9.5 to 1 head thickness? and pushrods, Don
Indexes:	[Date] [Thread] [Top] [All Lists]