- 1. [Roadsters] screw size? (score: 1)
- Author: Gary Tew <garytew@cox.net>
- Date: Sat, 13 Oct 2007 16:17:43 -0700
- I'm looking for the correct hardware to install the upholstered angled trim piece that goes around the back of the cockpit tub. Not sure if it uses nuts/washers or sheetmetal screws. Size? Thanks for
- /html/datsun-roadsters/2007-10/msg00217.html (6,362 bytes)
- 2. Re: [Roadsters] screw size? (score: 1)
- Author: "Graeme" <graemes@internode.on.net>
- Date: Sun, 14 Oct 2007 10:27:25 +0930
- --==1441074451== Content-Type: text/plain; charset="windows-1250" Content-Transfer-Encoding: 7bit Well, my Parts Manual says they are 3/32" machine screws BUT, when I check the body it appears that t
- /html/datsun-roadsters/2007-10/msg00218.html (7,825 bytes)
- 3. Re: [Roadsters] screw size? (score: 1)
- Author: "Matthew A. Smith" <matthews517@earthlink.net>
- Date: Sat, 13 Oct 2007 22:32:18 -0400
- Loreli came with 1/2 inch #8 machine screws. I replaced them with oval topped stainless screws and finish washers (the kind of hump shaped ones). Since then, I've replaced THOSE with screw in snap co
- /html/datsun-roadsters/2007-10/msg00220.html (8,205 bytes)
- 4. Re: [Roadsters] screw size? (score: 1)
- Author: "peter harrison" <granvillecomputing@hotmail.com>
- Date: Sat, 13 Oct 2007 22:57:52 -0700
- King Bolts 4680 N Grand Ave Covina, CA 91724 (626) 339-8400 They have the little 'shoulderless' finishing washers (stainless) that are replacements for the 6 washers that go on the cowl grille. (That
- /html/datsun-roadsters/2007-10/msg00227.html (9,949 bytes)
This search system is powered by
Namazu