| To: | datsun list datsun <datsun-roadsters@autox.team.net> |
|---|---|
| Subject: | [Roadsters] screw size? |
| From: | Gary Tew <garytew@cox.net> |
| Date: | Sat, 13 Oct 2007 16:17:43 -0700 |
I'm looking for the correct hardware to install the upholstered angled trim piece that goes around the back of the cockpit tub. Not sure if it uses nuts/washers or sheetmetal screws. Size? Thanks for the help/ Gary Tew Phoenix, AZ early '67 1600 ________________________________________ Datsun-roadsters mailing list http://www.team.net/archive http://autox.team.net/mailman/listinfo/datsun-roadsters |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [Roadsters] Carb cap and damper rod needed, kendelmccarley |
|---|---|
| Next by Date: | Re: [Roadsters] screw size?, Graeme |
| Previous by Thread: | [Roadsters] Carb cap and damper rod needed, kendelmccarley |
| Next by Thread: | Re: [Roadsters] screw size?, Graeme |
| Indexes: | [Date] [Thread] [Top] [All Lists] |