Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[Healeys\]\s+Replacing\s+Hypoid\s+Axle\s+Grease\s+Seal\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[Healeys\]\s+Replacing\s+Hypoid\s+Axle\s+Grease\s+Seal\s*$/: 5 ]

Total 5 documents matching your query.

1. [Healeys] Replacing Hypoid Axle Grease Seal (score: 1): Author: dcorning at ford.com (Corning, Dan (D.C.)); Date: Wed, 26 Apr 2017 22:24:26 +0000; I am trying to remove the rear axle hub and wheel bearing to replace the oil seal located behind them. After removing the axle shaft, retaining nut and lock washer, the photo shows the hub and bearin; /html/fot/2017-04/msg00318.html (8,349 bytes)
2. [Healeys] Replacing Hypoid Axle Grease Seal (score: 1): Author: healeydoc at sbcglobal.net (David Nock BCS); Date: Wed, 26 Apr 2017 16:09:31 -0700; Use a three hooked gear puller / slide hammer to remove the hub. David Nock British Car Specialists 209-948-8767 www.britishcarspecialists.com I am trying to remove the rear axle hub and wheel bearin; /html/fot/2017-04/msg00320.html (8,944 bytes)
3. [Healeys] Replacing Hypoid Axle Grease Seal (score: 1): Author: rchaskell at earthlink.net (Bob Haskell); Date: Wed, 26 Apr 2017 19:33:16 -0400; Dan, I don't think using bolts in the two/three holes will generate enough force to push the hub off. But I haven't tried it. I use a 3 arm puller; a 2 arm will work. I made a thick disc (1/2"?) that; /html/fot/2017-04/msg00321.html (10,197 bytes)
4. [Healeys] Replacing Hypoid Axle Grease Seal (score: 1): Author: austin.healey at gmail.com (Chris Dimmock [Healey]); Date: Thu, 27 Apr 2017 00:18:23 +0000; Hi Dan, If you have a spare axle, put it on the hub "backwards" so the axle shaft sticks out, put a small block of wood on the end of the axle tube (to protect it and start the bearing moving) and pu; /html/fot/2017-04/msg00322.html (9,957 bytes)
5. [Healeys] Replacing Hypoid Axle Grease Seal (score: 1): Author: eschulz at frontiernet.net (Elton Schulz); Date: Wed, 26 Apr 2017 22:32:09 -0400; Dan, If you don't have a 3 legged puller or a slide hammer, you can use a trick I learned from Andy Pole on this List. Get the half shaft and turn it backwards so that the domed end is against the ax; /html/fot/2017-04/msg00323.html (9,771 bytes)

Current List: 1 - 5
Page: [1]