Dan,
If you don't have a 3 legged puller or a slide hammer, you can use a
trick I learned from Andy Pole on this List. Get the half shaft and turn
it backwards so that the domed end is against the axle/hub and the studs
going through the half shaft holes. Use the nuts to tighten the half
shaft against the hub. The hub will then be pulled off the axle as you
tighten.
Good luck,
Elton
On 4/26/2017 6:24 PM, Corning, Dan (D.C.) wrote:
>
> I am trying to remove the rear axle hub and wheel bearing to replace
> the oil seal located behind them. After removing the axle shaft,
> retaining nut and lock washer, the photo shows the hub and bearing.
>
> The inner race of the bearing seems to have an interference fit with
> the axle housing. Can anyone tell me the proper method to remove the
> hub? Can I use two long ? inch bolts in the threaded holes in the
> photo to "push" the hub out and then use an appropriate sized bearing
> driver to reinstall?
>
> Best,
>
>
> Dan Corning
>
>
>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/eschulz at
> frontiernet.net
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20170426/93c89d98/attachment.html>
|