I am trying to remove the rear axle hub and wheel bearing to replace the oil
seal located behind them. After removing the axle shaft, retaining nut and
lock washer, the photo shows the hub and bearing.
The inner race of the bearing seems to have an interference fit with the axle
housing. Can anyone tell me the proper method to remove the hub? Can I use
two long ? inch bolts in the threaded holes in the photo to "push" the hub out
and then use an appropriate sized bearing driver to reinstall?
Best,
Dan Corning
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20170426/13017037/attachment.html>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: Hypoid Axle Hub.JPG
Type: image/jpeg
Size: 224305 bytes
Desc: Hypoid Axle Hub.JPG
URL:
<http://autox.team.net/pipermail/healeys/attachments/20170426/13017037/attachment.jpe>
|