Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*TR6\s+Bonnet\s+$Hood$\s+catch\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*TR6\s+Bonnet\s+$Hood$\s+catch\s*$/: 6 ]

Total 6 documents matching your query.

1. TR6 Bonnet (Hood) catch (score: 1): Author: Will <tr6@mac.com>; Date: Sun, 23 Jun 2002 19:06:34 +0100; Hi All, Hope someone on the list has an answer to this as it's driving me nuts! The bonnet began popping open whenever I hit a bump in the road, (i.e. all the time - I'm in London). I've been trying; /html/6pack/2002-06/msg00503.html (7,909 bytes)
2. Re: TR6 Bonnet (Hood) catch (score: 1): Author: jay_welch@juno.com; Date: Sun, 23 Jun 2002 20:47:59 -0400; Hello William, Could your bonnet latch pull cable be adjusted too short? This might not allow the latch to fully engage when the cable is released. Good luck, Jay Welch Abington, MA 1971 TR6 Project,; /html/6pack/2002-06/msg00509.html (9,140 bytes)
3. Re: TR6 Bonnet (Hood) catch (score: 1): Author: tr6taylor@webtv.net (Sally or Dick Taylor); Date: Sun, 23 Jun 2002 18:14:44 -0700 (PDT); William--If you lost track of where the adjustment should be, reset the overall length to 3-1/4", from bracket to the cup below the spring. This should give you a catch with reasonable opening pull.; /html/6pack/2002-06/msg00510.html (6,955 bytes)
4. Re: TR6 Bonnet (Hood) catch (score: 1): Author: "Michael Lupynec" <mlupynec@globalserve.net>; Date: Mon, 24 Jun 2002 09:19:37 -0400; Had the same symptoms - first it was obvious that the safety catch was sliding down the wrong side of the latch. Fixed that but no relief. Re-aligned the plunger assy to be perfect centre on the latc; /html/6pack/2002-06/msg00517.html (9,001 bytes)
5. Re: TR6 Bonnet (Hood) catch (score: 1): Author: "Michael Lupynec" <mlupynec@globalserve.net>; Date: Mon, 24 Jun 2002 10:23:50 -0400; Direct IRS quote from Roger Williams (How to Restore Triumph TR5/250 & TR6) "...on the end of each rear outer axle shaft there is a threaded portion that can snap off, and allow the wheel to come off; /html/6pack/2002-06/msg00521.html (8,704 bytes)
6. Fw: TR6 Bonnet (Hood) catch (score: 1): Author: "Michael Lupynec" <mlupynec@globalserve.net>; Date: Mon, 24 Jun 2002 11:35:52 -0400; Apologies to the list, but I sent this message earlier with wrong subject line. The discussion on catastrophic suspension failures is getting serious enough, so here I go again (c/w corrected subject; /html/6pack/2002-06/msg00523.html (9,391 bytes)

Current List: 1 - 6
Page: [1]