Re: [TR] Front Pullet Hub Removal

[Randy and Valerie DeRuiter <deruiterville@hotmail.com>]

Jim- to avoid bending anything I usually leave the fan extension on and I 
unthread the dog bolt slightly.  Then I use a puller against the lip of the fan 
extension and the dog bolt.  This will move it probably by 1/2 inch.  If the 
hub is still firmly stuck, I replace the dog bolt with a thinner bit longer 
bolt and pull against it until the hub clears its key.

Hope that makes sense
Randy

Sent from my iPhone

> On Jul 18, 2021, at 6:57 PM, Jim Henningsen <trguy75@gmail.com> wrote:
> 
> List:
> Converting my 67 4A over to the Bastuck narrow fan belt kit. This kit
> retains the fan extension tube and fan.   I have the radiator out and fan
> blade and fan extension removed.  I have the stock pulley at the top dead
> center position (hole at the top).  Have not removed one of these before.
> Any tips on removing would be greatly appreciated.  I still have the cross
> tube and was hoping it could be removed while that is still installed.
> Thanks in advance!
> Jim henningsen
> Ocala, FL
> 61 3A
> 67 4A
> 75 6
> 81 8
> 
> ** triumphs@autox.team.net **
> 
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/pipermail/triumphs  http://www.team.net/archive
> 
> Unsubscribe/Manage: 
> http://autox.team.net/mailman/options/triumphs/deruiterville@hotmail.com
** triumphs@autox.team.net **

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/pipermail/triumphs  http://www.team.net/archive

Unsubscribe/Manage: 
http://autox.team.net/mailman/options/triumphs/mharc@autox.team.net