I've done it twice and both times did engine/trans/od as a single unit.
Watch the area on the gearbox where the speedometer cable attaches - it is
easily damaged if you are concentrating too much on the front of the car (he
speaks from experience.....)
Andrew Uprichard
-----Original Message-----
From: triumphs-bounces@autox.team.net
[mailto:triumphs-bounces@autox.team.net] On Behalf Of Angelo Graham
Sent: Sunday, August 09, 2009 6:54 PM
To: triumphs@autox.team.net
Subject: [TR] Installing engine in TR2/3
Hello Listers:
Approaching the engine installation stage on my long TR2 resto and
wondering if installing engine/trans/od as a unit makes more sense
than mating trans to engine in the car. The engine compartment is
freshly painted, so some anxiety around clearances, etc. Have got the
steering cross-shaft out, so have a bit more clearance from the front.
Any advice from past experiences? Engine and trans came out
separately, but that operation is usually easier with old paint in
engine compartment.
Thanks for any help with this.
Angelo Graham
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|