Don't forget the three bolts/clamps on top of the dash at the bottom of the
windshield. As you noted the corner frame bolts that you've already loosened
are at an angel so you have to pull the windshield up at that same angel.
However, those corners can get rusted in place to the point where some guys
have had to resort to a dremel cutting wheel to get it off.
Bob Danielson
1975 TR6 CF38503U
Running w/ Throttle Body Injection
Toyota 5 Speed & Nissan LSD
http://tr6.danielsonfamily.org
-----Original Message-----
From: triumphs-bounces@autox.team.net
[mailto:triumphs-bounces@autox.team.net] On Behalf Of William Brewer
Sent: Sunday, July 12, 2009 11:14 AM
To: Triumphs
Subject: [TR] TR6 Windshield Frame Removal
I am stripping my TR6 down for painting. I want to change remove the
rubber seal between the windshield frame and the scuttle. I loosened the two
nuts that appear to hold the windshield frame on. They are in the outer wall
of the footwell below the windshield frame corners and leading forward at
about a 30 degree angle. I tried rocking the frame back and forth while
pulling up and back. This thing won't budge. Is there some secret technique
for getting the windshield frame off? TIA,
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|