Paul,
Just replaced it too, I don't know what size stock is but what was on there
was 3/16" and seemed like a perfect fit. You can buy a piece of steel brake
line at your local FLAPS for about $6.00, add you fittings, bend and flare
it ... Bob's your uncle!
Bill Beecher
'58 TR-3A TS/30766 L (On the road in 2009!)
'59 TR-3A TS/64974 LO (in buckets, for sale... anyone?)
"A Triumph is man's best friend, it always comes when it is called...of
course, some times it is difficult to make it go"
-----Original Message-----
From: triumphs-bounces@autox.team.net
[mailto:triumphs-bounces@autox.team.net] On Behalf Of Bob
Sent: Tuesday, May 05, 2009 7:42 PM
To: triumphs@autox.team.net
Subject: [TR] thickness of clutch mc to slave line?
I recently used the stock pipe piece from TRF PN 148816.
It required minimal reshaping and worked just fine.
Regards,
Bob
>
> On May 5, 2009, at 5:44 AM, dorpaul wrote:
>
> > Hi,
> >
> > Is it correct to use the same size tubing between the Clutch MC and
> > it's slave cylinder as that of the brake line (I think that's 1/8"
> > tubing, right?).
> > Is there any benefit to using a larger diameter tubing for this
> > line? If so, I'll need to obtain fittings for the larger tube (from
> > where?).
> >
> > Thanks, Paul Dorsey
> > _____
>
E-mail message checked by Spyware Doctor (6.0.0.386) Database version:
5.12320 http://www.pctools.com/en/spyware-doctor-antivirus/
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
You are subscribed as wbeech@flash.net
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|