Thanks to John and Randall on the wiring harness issue. The schematic nailed
it. I will try pulling the horns apart as Randall suggested. Sounds like the
area to attack. Thanks again guys.
Alex
----- Original Message -----
From: "John Wise" <60TR3A@cox.net>
To: "Eureka Saws Co, Inc." <ambritts@ptdprolog.net>
Sent: Wednesday, June 21, 2006 08:45 PM
Subject: Re: [TR] Harness TR3
> >Hi All,
> >Need some direction on the install of my harness. 59 TR3A. At the
regulator,
> >fuse box area I have 4 green wires. I can account for 3 on the fuse
block. My
> >other 2 used harnesses do not have this 4th green wire? Any ideas? Now
I'll
> >push my luck. I have 4 wind tone horns. 2 hi 2 low. I tested all 4 and
only 1
> >low tone works nicely. The normal points adjustment does not bring the
other 3
> >to proper tone at all. Any ideas. My test was conducted directly off a
battery
> >with jumper leads.
> >Alex Manzo
> >59 TR3A
> >72 TR6
>
> I have attached Dan Massey's wiring diagram, maybe it will help.
> --
> John A. Wise
> Glendale, AZ
>
> Email: 60TR3A@cox.net
>
> 1960 Triumph TR3A
> Commission No: TS80422L
> http://members.cox.net/60tr3a/index
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|