> Need some direction on the install of my harness. 59 TR3A. At the
> regulator,
> fuse box area I have 4 green wires. I can account for 3 on the
> fuse block. My
> other 2 used harnesses do not have this 4th green wire? Any
> ideas?
Could it be the green wire for the turn signal flasher ? Or possibly brake
light switch ?
If nothing else, you could always connect them one at a time, and see which
devices work. Assuming the harness follows the color codes, it won't hurt
anything to hook a green wire to the fuse block. Besides, that's a fused
circuit, so the worst that could happen is a blown fuse.
> Now I'll
> push my luck. I have 4 wind tone horns. 2 hi 2 low. I tested all
> 4 and only 1
> low tone works nicely. The normal points adjustment does not
> bring the other 3
> to proper tone at all. Any ideas.
I've resuscitated several of them by removing the points assembly and
pulling out the pushrod below them, that carries motion from the diaphragm
inside to the points. The hole tends to get dirty and/or corrode, causing
the pushrod to stick. Still not sure what is best to prevent more
corrosion/dirt, but a very thin layer of white grease on the pushrod seems
to help.
Randall
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|