Hi Paul,
I think I get you. The bit that the wiper slips on to obviously sticks
through the hole. In my car I put the cable in the lower of the 2 positions
(about 1" below the scuttle plate and closer to the bulkhead / engine). Not
100% if it was the right way but it seems to fit and work OK.
Chris Buckley
Does the long drive-cable "thread" through the wiper wheelboxes so that this
cable is on the top or bottom of the wheelbox as it sits normally under the
dash of my TR3?
If the cable goes on top then this cable-drive will be 1/4" from the body's
sheet metal, but if it goes on the bottom of the wheelbox then it will be 1"
from the body's sheetmetal.
--
This message has been scanned for viruses and
dangerous content by Africa Online Tanzania, and is
believed to be clean.
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|