Hello List:
Asking about experiences installing original rear seal on TR wet sleeve
engines. Did most make up a mandrel according to manual specs and use this
to center seal halves?
Any other techniques to center seal? Seems centering using mandrel, then
removing and installing crank, then re-installing seals leaves lots of room
for loosing original setting.
At this point in engine re-build, so wondering if going off and making up a
mandrel and following the book is the way to proceed.
Thanks for any insights.
Angelo Graham
'55 TR2
Check out the new British Cars Forum:
http://www.team.net/the-local/tiki-view_forum.php?forumId=8
|