TR2/3 installation of rear seal ("http://j-chkmail.ensmp.fr")! 0.75g on localhost

[Angelo Graham <a3graham@admmail.uwaterloo.ca>]

Hello List:
Asking about experiences installing original rear seal on TR wet sleeve 
engines. Did most make up a mandrel according to manual specs and use this 
to center seal halves?
Any other techniques to center seal? Seems centering using mandrel, then 
removing and installing crank, then re-installing seals leaves lots of room 
for loosing original setting.
At this point in engine re-build, so wondering if going off and making up a 
mandrel and following the book is the way to proceed.
Thanks for any insights.

Angelo Graham
'55 TR2

Check out the new British Cars Forum:
http://www.team.net/the-local/tiki-view_forum.php?forumId=8