TR-4 Rear Main Seal

To:	"tri" <triumphs@autox.team.net>
Subject:	TR-4 Rear Main Seal
From:	"Paul Dorsey" <dorpaul@negia.net>
Date:	Tue, 3 Aug 2004 16:58:04 -0400

I just ordered a Rear seal conversion kit from TSI and I was told that the
manufactor no longer recommends milling the crankshaft down to 62.5mm but
instead to 63.5mm (in order for the crankshaft to exhert more pressure on the
seal.)  Is this possibly the fix your after?

Thanks,
Paul Dorsey
66 TR4 engine

Check out the new British Cars Forum:
http://www.team.net/the-local/tiki-view_forum.php?forumId=8

<Prev in Thread]	Current Thread	[Next in Thread>
Re: TR-4 Rear Main Seal, (continued) Re: TR-4 Rear Main Seal, Peter Murray RE: TR-4 Rear Main Seal, Unknown RE: TR-4 Rear Main Seal, Randall RE: TR-4 Rear Main Seal, Unknown RE: TR-4 Rear Main Seal, Dave Massey RE: TR-4 Rear Main Seal, Unknown RE: TR-4 Rear Main Seal, Randall RE: TR-4 Rear Main Seal, Unknown RE: TR-4 Rear Main Seal, Dave Massey TR-4 Rear Main Seal, Unknown TR-4 Rear Main Seal, Paul Dorsey <= RE: TR-4 Rear Main Seal, Unknown RE: TR-4 Rear Main Seal, Randall RE: TR-4 Rear Main Seal, Unknown RE: TR-4 Rear Main Seal, Jeff Tedder RE: TR-4 Rear Main Seal, Unknown RE: TR-4 Rear Main Seal, Jack W. Drews

Previous by Date:	TR-4 Rear Main Seal, Unknown
Next by Date:	RE: Distributor Question, Unknown
Previous by Thread:	TR-4 Rear Main Seal, Unknown
Next by Thread:	RE: TR-4 Rear Main Seal, Unknown
Indexes:	[Date] [Thread] [Top] [All Lists]