> I just ordered a Rear seal conversion kit from TSI and I was told that the
> manufactor no longer recommends milling the crankshaft down to 62.5mm but
> instead to 63.5mm
Paul, I'm not sure if Ted sells the same seal kit that Racetorations and BFE
do ... but I have a set of instructions from Racetorations that have the
2.500" (63.5mm) dimension scratched out, and 2.520" hand-written in.
You might want to double-check that the 63.5mm dimension isn't someone's
"senior moment" before having your crank ground.
Randall
Check out the new British Cars Forum:
http://www.team.net/the-local/tiki-view_forum.php?forumId=8
|