How do these sleeves work? Are they a cylinder or a strip of metal. What
about bonding?
Mark Hooper
-----Original Message-----
From: Randall Young [mailto:ryoung@navcomtech.com]
Sent: Thursday, March 13, 2003 1:40 PM
To: triumphs
Subject: RE: #%$^@#!@# diff pinion seal!
> Darrell, I have had better luck with the rubber seal, but before you put
> any seal in make sure you check the pinion flange for seal wear. You
> may want to use some crocus cloth to clean up any wear. If its bad,
Note that "bad" is a relative term, in this location I'd say anything you
can catch a fingernail in is "bad". And, I've seen some leak where you
could only see the wear mark, not feel it even with a fingernail. So, I
always dress it with crocus cloth until I can't see the wear mark, or else
put on a sleeve.
Randall
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|