Hello all,
To follow up on my question 2 weeks ago, I received my new dash and finally
completed the installation. The new dash looks great and the only problems
with fitting it in was I needed to get a new hazard switch, the one I had was
slightly larger then the whole that was routed out in the dash and I
discovered that I need to order a new switch that is slightly smaller made
especially for the TR250, I think the one I had was for a 1972 TR6. The other
problem was with the glove box lock. The whole that Randy routed out for it
in the dash door would only fit the lock and there was no room for the finger
pull!
I had also ordered a piece of wood to match the dash for the center section
right below the dash where the Ignition goes but I was unable to use this
piece because there was only 4 wholes routed out in it, and I needed 5. Randy
was very nice about it and told me he would make me a new one...but remember
it took me 9 months to get this one from him?!?
Just an added note I also installed a new pair of K&N air filters and a new
rocker oil feeder line.
If you would like to check these projects out or to see pictures, you can go
to my web site http://www.triumphtr250.com
Again Thanks for the help,
John
http://www.triumphtr250.com
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|