I am finishing up a frame off of my 76 TR, I think it's been only 4 years but
according to my wife it's been a lot longer. The question I have is I'm tring
to test the dash lights (guages) and I cannot seem to get the right
combination to see if everything works. I have grounded the harness - 2
grounds in the new harness, I have turned on the light switch and I have
connected the reostat. So far all that comes on and this is according to the
diagram is the ignition light.
I want to make sure all is well before putting the dash back in. I am looking
for some input as to how to go about this.
Thanks Crabby
Ontario 76TR6
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|