Message text written by INTERNET:hfader@usa.net
>I'm surprised. I was under the impression that the holes had to be
align-bored. Can you give information about how to do this and where to get
the reamer? Don't have a contact for Brian Schlorff.<
Yes they are align bored, and the reamer has a shaft that is the ID of the
original hole and the reamer
has an OD of the replacement bush minus half a thousandth.
So, you slide the shaft of the reamer thru the both bores and ream from the
outside-in on one bore, then press in the
bush, cut down the excess (use the reamer carefully for this), then flip the
reamer and do the other side.
I forgot to give you the contact info for Brian.
Britcars@powerbritish.com
-Tony
/// triumphs@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe triumphs
///
/// or try http://www.team.net/cgi-bin/majorcool
|