Gary, mine is wired as follows: About 2-3" before the wires you mention
split out from the harness, there's a blk wire that grounds to the front
edge of the master cylinder housing. As for the wiper motor, the blk/grn
goes to the #1 screw, the green to the #2 screw, and the blk wire goes to E.
Then, there's another short length of blk that continues on from the "E"
post to the rearmost bolt that holds the wiper motor housing to the tub (the
bolt nearest the wing). Not sure if mine LOOKS like it's supposed to, but
the wipers do work.
Michael Ferguson
1959 TR3A TS53990L...O
----------
>From: Gbouff1@aol.com
>To: Triumphs@autox.team.net
>Subject: Need wiring advice, TR3A wiper motor
>Date: Tue, Jan 2, 2001, 11:33 PM
>
>
> Listers,
>
> This is probably the first of many electrically related questions, so please
> bear with me.
>
> I am in the process of installing a new harness on my pre 60000 TR3A that has
> a combination of spade and bare wire connections, probably as a result of
> it's late build date, TS 58399.
>
> My wiper motor has a build date of July 59 and has 3 screwed on spade
> connectors that are labeled 1, 2, and E. E is part of the housing and
> obviously the ground (E arth). The other two wires are solid green, and
> green with a black stripe. What connects to what?
>
> Thanks,
>
> Gary Bouffard (Spark after Dark)
> TS 58399
|