In a message dated 11/29/2000 3:37:12 PM Pacific Standard Time,
105671.471@compuserve.com writes:
<< This is the tape used in lieu of the rubber sleeves that never stay put
anyway.
Humbly greateful,
Dave >>
Dave,
I don't remember if this was the list I saw it discussed on, but I thought
the bottom line was that it was very similar to electrical tape, but wider.
I used electrical tape back in '69 and it worked then. Should work now I
would think.
Someone also suggested silicone caulk on the end of each spoke, inside the
wheel, to prevent rust from running down the spoke. I guess this would work
inside the splined hub to prevent grease running out too.
RH
|