Re: TR7 BFH#30 --- holding crank

[ZinkZ10C@aol.com]

There are a couple of ways.

One is to find a piece of steel that will bolt to a bellhousing hole and 
engage the flywheel ring gear.

The other method is to bolt a ~ 3 ft piece of steel or wood to two of the 
clutch mounting holes.  This will allow you to wedge the wood on the ground 
while you torque the bolts.

If you leave the engine on the " hook" be sure not to roll the engine and 
dislodge it fron the hook.

Harold