My rear suspension rebuild is going well with all the list help. But,
when I went to release the 6 nuts to remove the right half-axle/hub
assembly, 4 out of 6 studs unscrewed totally. It appears that the
threads were good, but now I have 4 full studs with nuts which are at
the point at which they were tightened down. I assume there may be no
problem if I can screw them back in carefully with a torque wrench. Any
comments as to returning the studs properly - to avoid stripping out the
aluminum threads in the trailing arms, would be much appreciated.
Thanks for your help, D. Michael
|