I've got the left side front suspension disassembled except for removing the
inner wheel bearing and the oil seal that sits inboard of it. Even though
I've removed a great deal of grease from the front hub assembly it's
difficult to see what's available to press or hit.
Should I be able to pry the oil seal off or use a dowel to tap the seal and
bearing out from the outside of the hub? I checked the TR6 web site at MIT
but didn't see anything about bearing removal.
I'd like to get the big parts to a shop for sandblasting and perhaps powder
coating tomorrow or the next day, so I'm kind of in a hurry here. Any
advice cheerfully accepted.
Thanks,
Skip Montanaro | Mojam: "Uniting the World of Music" http://www.mojam.com/
skip@mojam.com | Musi-Cal: http://www.musi-cal.com/
518-372-5583
|