tigers
[Top] [All Lists]

Re: [Tigers] Valve Cover Removal

To: <rfraser@bluefrog.com>, "'hallmotors'" <hallmotors@cox.net>, <tigers@autox.team.net>
Subject: Re: [Tigers] Valve Cover Removal
From: "Dave Munroe" <dave@munroe.ca>
Date: Sat, 1 Nov 2014 16:18:24 -0300
Delivered-to: mharc@autox.team.net
Delivered-to: tigers@autox.team.net
References: <E58EE8A576F3492C8380DFBC7315880E@ronpc1>
Yeah, that's about right Ron, not 20-50 ft lb like some guys I know!

Dave


----- Original Message ----- 
From: " Ron Fraser" <rfraser@bluefrog.com>
To: "'Dave Munroe'" <dave@munroe.ca>; "'hallmotors'" <hallmotors@cox.net>; 
<tigers@autox.team.net>
Sent: Saturday, November 01, 2014 3:16 PM
Subject: RE: [Tigers] Valve Cover Removal


Also, a good trick with Small block Ford valve cover gaskets is not to
tighten up the cover bolts too much. Barely finger tight and a bit is
enough. The steel covers distort easily and rise up almost out of contact
between the bolts. The alloy ones crack very easily. It's amazing how well
they seal with very little pressure.

Good luck with this Brad, and happy knuckle whacking!

Dave
-----------------------------------

The torque value I have for the valve cover bolts is 3 - 5 ft lbs - retorque
after the gasket has time to compress

Ron Fraser
_______________________________________________

tigers@autox.team.net

Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/tigers/mharc@autox.team.net


<Prev in Thread] Current Thread [Next in Thread>