To: | "'Dave Munroe'" <dave@munroe.ca>, "'hallmotors'" <hallmotors@cox.net>, <tigers@autox.team.net> |
---|---|
Subject: | Re: [Tigers] Valve Cover Removal |
From: | " Ron Fraser" <rfraser@bluefrog.com> |
Date: | Sat, 1 Nov 2014 14:16:45 -0400 |
Delivered-to: | mharc@autox.team.net |
Delivered-to: | tigers@autox.team.net |
Thread-index: | Ac/1+ZtovBrYIBq6RmWNZvqiDsaVkgABb60g engine=2.50.10432:5.12.52,1.0.28,0.0.0000 definitions=2014-11-01_03:2014-10-31,2014-11-01,1970-01-01 signatures=0 spamscore=0 suspectscore=0 phishscore=0 adultscore=0 bulkscore=0 classifier=spam adjust=0 reason=mlx scancount=1 engine=7.0.1-1402240000 definitions=main-1411010186 |
Also, a good trick with Small block Ford valve cover gaskets is not to tighten up the cover bolts too much. Barely finger tight and a bit is enough. The steel covers distort easily and rise up almost out of contact between the bolts. The alloy ones crack very easily. It's amazing how well they seal with very little pressure. Good luck with this Brad, and happy knuckle whacking! Dave ----------------------------------- The torque value I have for the valve cover bolts is 3 - 5 ft lbs - retorque after the gasket has time to compress Ron Fraser _______________________________________________ tigers@autox.team.net Archive: http://www.team.net/archive Unsubscribe: http://autox.team.net/mailman/options/tigers/mharc@autox.team.net |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [Tigers] Valve Cover Removal, Tom Parker |
---|---|
Next by Date: | Re: [Tigers] Valve Cover Removal, Dave Munroe |
Previous by Thread: | Re: [Tigers] Valve Cover Removal, Tom Parker |
Next by Thread: | Re: [Tigers] Valve Cover Removal, Dave Munroe |
Indexes: | [Date] [Thread] [Top] [All Lists] |