Hi Bob,
You're right on the spark voltage bit, of course, and I'll keep that in mind
as I hunt for parts.
Mostly I'm after a 'clean' look. Some of it won't be stock, some of it will,
and it shouldn't be immediately obvious where the stock ends and the custom
stuff starts. Above all, it has to WORK.
Theo
-----Original Message-----
From: Bob Palmer [mailto:rpalmer@ucsd.edu]
Sent: Thursday, October 05, 2000 11:01 PM
To: Smit, Theo; 'Tigers'
Subject: RE: Dist. Cap
Theo,
The parameter that directly determines the spark voltage is the spark plug
gap.
<snip>
I think a good set of 7 mm wires will
work just fine too, in case you are after that "stock" look.
Good luck,
Bob
|