I believe all axle tubes have a vent (top, near center). It can be
unscrewed and filled from there, though the hole is a bit small.
Gerard
At 3:56 PM -0400 9/26/01, mgraziano@mindspring.com wrote:
>Peter's right. Go figure. You might end up with either two filler plugs,
>or none. Neither is an issue if you fill it up from the axle tube on a
>slant. But be sure not to overfill it. ANyone remember the recommended
>oil capacity of the differentials?
>
>Mike
>
>
>"Peter C." <nosimport@mailbag.com> wrote:
>> If memory serves, at some point in the lineage of these third members, the
>filler plug or drain plug atrophies. Take a look at that so you are prepared.
> Peter C
>=====
>At 02:04 PM 9/26/2001, Roger Cotting wrote:
>>Yes. Time to replace your gaskets and O-rings at axle ends. Check tightness
>>of big nuts. And change rear end fluid.
>>
>> > Dear list
>> > I am about to buy a 3.9 rear end from a 76 Midget. Will this just bolt
>>into
>> > housing for my 4.33 Bugeye?
>> >
>> > David Oliner
>> > 60 Bugeye
>> > 67 TR 4A
>
--
Please visit Four Points Travel -
Discount Online International Travel Reservations
http://www.gerardsgarage.com/fourpoints
To make a reservation please call Toll Free 1-800-272-3253
G G Gerard Chateauvieux
E A
R R pixelsmith@gerardsgarage.com
A A
R G Pixelsmith on Duty
D E
S http://www.gerardsgarage.com
|